Shoulder belt mod

Forum for all things CJ

Moderator: Board of Directors

Post Reply
Jurassic_CJ8
Newbie
Posts: 21
Joined: Sun Mar 22, 2009 2:13 pm

Shoulder belt mod

Post by Jurassic_CJ8 » Wed Jun 20, 2012 3:46 pm

Hi,

I spoke with my local shop yesterday about modifying the roll bar on my 1981 CJ-8 so that it will accept a shoulder seat belt. We decided on drilling a 1.25" hole on each side and welding in a 1" long piece of rod that is threaded for a 7/16" bolt. I'll use a short bolt when topless and long bolt that extends through the factory cab holes when using a hard half top.

My question - do you know where I can get the threaded rod segments to weld into the bar? Any other ideas are welcome too. Thanks!

Patrick

Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests