Halltrail TJ skid owners + Fumoto Valve
Moderator: Board of Directors
- sherwoodiv
- Active Member
- Posts: 369
- Joined: Mon Sep 20, 2010 3:58 pm
- Location: Severna Park
Halltrail TJ skid owners + Fumoto Valve
I was curious how much bending people with halltrail skids have had near the oil drain plug on TJs. I got one of those Fumoto valves since I'm lazy and on my YJ I've not found the exact funnel system that wont overfill and get oil everywhere. I thought I would try out the Fumoto valve with the nipple. Here is a pic of it installed without the skid. The YJ had no bending but I was only running blues.
91 YJ with some rust
01 TJ barely legal
01 TJ barely legal
Re: Halltrail TJ skid owners + Fumoto Valve
Is that sticking out past the skid? I would remove that immediately and put the stock bolt back in.
50K
- sherwoodiv
- Active Member
- Posts: 369
- Joined: Mon Sep 20, 2010 3:58 pm
- Location: Severna Park
Re: Halltrail TJ skid owners + Fumoto Valve
Hello thread archeologist!
It can't stick out past the skid.
7 month review...
The skid also hasn't flinched to several beat downs. It doesn't look any closer to the valve. I think I'm good, until I'm not good, even then I bet the nipple will deform before it leaks.
It can't stick out past the skid.
7 month review...
The skid also hasn't flinched to several beat downs. It doesn't look any closer to the valve. I think I'm good, until I'm not good, even then I bet the nipple will deform before it leaks.
91 YJ with some rust
01 TJ barely legal
01 TJ barely legal
Re: Halltrail TJ skid owners + Fumoto Valve
Ha, I swear this thread was at the top. I didn't go digging for sure.
That's awesome.
That's awesome.
50K
- halltrail
- The Board
- Posts: 3185
- Joined: Sun Apr 15, 2007 1:26 pm
- Location: Calvert County, MD
- Contact:
Re: Halltrail TJ skid owners + Fumoto Valve
This of course is the most important part of this conversation. lolsherwoodiv wrote:...
The skid also hasn't flinched to several beat downs. .
99 TJ, 3spd auto, 4.5" BDS Lift, JKS 1.25" BL/1" MML, SYE, 36" TSL Bias, D44 rear - ARB locker, HP44-spool upfront, 4.56 gears, Hydro assist.
- sherwoodiv
- Active Member
- Posts: 369
- Joined: Mon Sep 20, 2010 3:58 pm
- Location: Severna Park
Who is online
Users browsing this forum: No registered users and 1 guest