HAY DAVE!

Trail Armor - Specializing in Engine Skid Plates.

Moderator: Board of Directors

Post Reply
User avatar
john3676
Active Member
Active Member
Posts: 2681
Joined: Wed Dec 10, 2008 9:56 am
Location: Eastern Shore

HAY DAVE!

Post by john3676 » Thu Jun 24, 2010 10:04 am

Hay I was just trying to see if you would be interested and doing a TC skid for the XJ. I was pondering if you could integrate and mount a ladder bar on to the axle and go to the TC skid. I can't drive it just yet, but wanted to give you a heads up as to what I was trying to do. let me know if you need more pics of the ladder bar and or the XJ. I should be ordering the driveshaft in 2 weeks, and should take 2 weeks to make it so we should be looking good to go in the 1st week of AUG.

thanks
BIGJOHN :biggrin:
Attachments
ladderbar.jpg

RkyMtnH
Active Member
Active Member
Posts: 1748
Joined: Thu May 07, 2009 10:23 am

Re: HAY DAVE!

Post by RkyMtnH » Thu Jun 24, 2010 10:07 am

I'm not Dave , but that looks nice .
If you see me driving a Jeep, don't wave. It's not me.

User avatar
halltrail
The Board
The Board
Posts: 3184
Joined: Sun Apr 15, 2007 1:26 pm
Location: Calvert County, MD
Contact:

Re: HAY DAVE!

Post by halltrail » Thu Jun 24, 2010 10:35 pm

Hey John, yea we should be able to work that out...I should be good by August...
99 TJ, 3spd auto, 4.5" BDS Lift, JKS 1.25" BL/1" MML, SYE, 36" TSL Bias, D44 rear - ARB locker, HP44-spool upfront, 4.56 gears, Hydro assist.

User avatar
john3676
Active Member
Active Member
Posts: 2681
Joined: Wed Dec 10, 2008 9:56 am
Location: Eastern Shore

Re: HAY DAVE!

Post by john3676 » Thu Jun 24, 2010 10:36 pm

Thanks

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest